Teesa TSA2010, Owner'S Manual

EN

Owner’s manual

10

Please read this operation instruction carefully before use. Please keep this operation 

instruction for future use. 

SAFETY INSTRUCTIONS

1.  Use iron only for its intended use.

2.  To protect against a risk of electric shock, do not immerse the iron in water or other liquids.

3.  The iron should always be turned to “min” before plugging or unplugging from outlet. 

Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.

4.  Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. 

Loop cord loosely around iron when storing.

5.  Always disconnect iron from electrical outlet when filling with water or emptying, and 

when not in use.

6.  Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To 

avoid the risk of electric shock, do not disassemble the iron. Take it to a qualified service 

point for examination and repair. Incorrect reassembly can cause a risk of electric shock 

and fire when the iron is used.

7.  Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you 

turn a steam iron upside down – there may be hot water in the reservoir.

8.  If the malfunction indicator goes on, or occur any abnormality, the iron is not operating 

normally. Disconnect from the power supply and have the device serviced by qualified 

service personnel.

9.  The iron must be used and rested on a stable surface.

10. The iron is not to be used if it has been dropped, it’s leaking, or there are visible signs of 

damage on the device or its cord.

11. This appliance is not intended for use by persons (including children) with reduced 

physical, sensory or mental capabilities, or lack of experience and knowledge, unless they 

have been given supervision or instruction concerning use of the appliance by a person 

responsible for their safety.

12. Close supervision is necessary for any appliance being used by or near children. 

13. Do not leave iron unattended while connected or on an ironing board.

14. Children should be supervised to ensure that they do not play with appliance.

15.  The plug must be removed from the socked-outlet before the water reservoir is filled with 

water.

WARNING!

1.  To avoid a circuit overload, do not operate another high wattage appliance on the same 

circuit.

2.  Iron should be connected directly to power supply socket (do not use extension cords).

REMEMBER

DO NOT

 let children or untrained persons use the appliance without supervision.

NEVER

 immerse the iron, cable or plug in any liquid.