Teesa TSA2010, Owner'S Manual

EN

Owner’s manual

14

VERTICAL

STEAM

BOOST

This iron has function of steam burst even while it’s positioned vertically.

Hold the iron vertically, press the steam burst button, and gently touch the fabric with 

soleplate. 

WARNING

: Be careful, released steam is hot and may cause scalds. Do not iron garments 

while wearing it.

ANTI-DRIP

This iron is equipped with a drip-stop function: when the iron’s temperature is too low, the 

steaming function  automatically stops to prevent water from dripping out of the soleplate.

ANTI-CALC

The Anti-calc function filtrate the minerals from the water to prevent mineral residue build 

up at the steam chamber.

DEFECTS AND REPAIRS

Do not attempt to replace a defective mains cable. The appliance has to be returned to an 

authorized service center for repair.

TROUBLESHOOTING

Iron emits an odor or smoke

•  Iron gives off an odor when turned on for the first time. Oils used during manufacture 

need to be burnt off. The odor will disappear within 10 minutes.

Iron does not steam

•  The water tank may be empty. Unplug the iron from the mains supply and turn the steam 

ruler to “0” and add water. Leave the iron for few minutes to heat (depending on selected 

temperature), and then set the steam dial to the steam setting.

Burst of steam feature does not work

•  The water tank must be fill up to minimum indicator at least. Fill the iron as described 

in the section “how to fill the water tank”. Temperature must be set to steam position. 

Iron should be in the horizontal position. Prime pump briefly. Make short pauses between 

shots. Be sure you depress the burst of steam button fully.

Spry mist feature does not work

•  The water tank must be fill up to minimum indicator at least. Fill the iron as described in 

the section “how to fill the water tank”, and try again.

Iron is leaking

•  The steam ruler must be set off, until the iron is hot. If the set temperature is too low, the