EN
Owner’s manual
18
2. Use the “+” and “-” buttons to set the heating running time (the setting range is 0 to 24
hours). Once the timer icon stops flashing, the preset timer off function will be activated.
3. When the set time runs out, the heater will turn off automatically. The timing and heating
screen are displayed alternately.
Note: If the temperature is set before setting the timer automatic off function, the heater
will run on and off according to the set temperature until the timer automatic off and time is
exhausted (the default initial value of the timer automatic off time is “0” hours).
*If there is no operation within 5 seconds, the function will automatically exit.
Timer setting (automatic turn on)
This function have two ways to use it:
1. The heater plug out, then plug in again.
Press the MODE button when the heater is off, it will enter to the automatic startup setting
program (the setting range is 0 ~ 24 hours) and then automatically start the heating process.
If no operation is performed within 5 seconds, the function will automatically exit.
Note: The function of setting timer on automatically means that the heater will use in the
third gear according to the default temperature setting (24°C).
1. Press the MODE button until the timer icon blinks and the number of hours on the
screen is displayed.
2. Use “+” and “-” buttons to set the automatic opening time of the heater (the setting range
is 0 ~ 24 hours). Once the timer icon stop flashing, the automatic opening function of the
timer will be activated.
3. When the set time runs out, the heater will turn on automatically.
2.The heater turn off, but without disconnecting the power.
Press the MODE button when the heater is not open, it will enter to the automatic startup
setting program (the setting range is 0 ~ 24 hours) and then automatically start the heating
process. If no operation is performed within 5 seconds, the function will automatically exit.
Note: The function of setting timer to automatically open, the heater will operate according
to the temperature setting and gear when it is started.
1. Press the MODE button until the timer icon blinks and the number of hours on the screen
is displayed and also will have the icon for automatic open.
2. Use “+” and “-” buttons to set the automatic opening time of the heater (the setting range
is 0 ~ 24 hours). Once the timer icon stops flashing, the automatic opening function of
the timer will be activated.
3. When the set time runs out, the heater will turn on automatically.
NOTE:
It takes time for the oil heater to increase or decrease the temperature. When the room
temperature is higher than the set temperature, the heater would stop. When the room
temperature is lower than the set temperature, the heater would continue to heat up.
