TOP VIEW
INSIDE VIEW
Figure 12
Figure 13
Figure 15
Figure 14b
Figure 14a
A S S E M B L E TA B L E B E D T O A- F R A M E
Failure of the Self-Locking Hooks to close over
both Roller Hinge Pivot Pins is an indication of
improper assembly and if not corrected could
result in serious injury or death!
WARNING
!
Figure 15:
Rotate the Table Bed so that it is facing
up. Ensure that it rotates smoothly.
See also Image A on Page 16 to ensure
misassembly has not occurred.
Figure 13:
Lower each Roller Hinge Pivot Pin into
the A-Frame hinge plates, one side at a time.
The Self-Locking Hooks will open to allow the
Pivot Pin into the Hinge Plate slot, then
automatically snap closed over the Pivot Pin.
TIP:
You may need to push outward on the
Hinge Plate in order for the second Pivot Pin
to lock in place.
Figure 14a & 14b:
Make sure that each Pivot Pin is
seated at the base of the slot in the Hinge Plates,
and that the Self-Locking Hooks have closed over
both Pivot Pins.
Figure 12:
Face the front of the A-Frame where
the Crossbar is located. Grasp both Roller Hinges,
right above the Cam Lock, and lift the Table Bed.
Allow the top of the Table Bed to rotate toward
the floor, so that the back of the Table Bed is
now facing you and the top of the Table Bed is in
front of the Crossbar.
S T E P 4
9
Summary of Contents for EP-560
Page 24: ...This page intentionally left blank 22 ...
Page 27: ......