STEP 1
Assemble Table Frame to the Base
NOTE:
The Table Bed arrives rotated into the fully inverted position. This
is the most convenient position from which to begin the
assembly process.
• Place the Base flat on the floor, with the holes up (Figure 1). The holes
in the Base are off-center toward the front.
• Place the Table Frame upright on its legs on top of the Base, with the
smaller, angled legs pointing in the same direction as the front of the
Frame Base.
• Align the six (6) holes and insert a Bolt and Washer through each hole
on both sides of the Base (Figure 2).
• Loosely tighten the Bolts until certain that all of the holes are aligned
properly, then securely tighten with a 19 mm wrench.
FIGURE 1
FIGURE 2
FRONT
REAR
7
