TEFAL PT3080, Manual

8

•  Indication of air quality

Air quality indicator (12) is located at the front panel (C) of the appliance. The 3 LED will indicate the air quality 

level: 

Air Quality

Air quality indicator color

Excellent

Blue

Slight pollution

Green

Moderate pollution

Yellow

High pollution

Orange

Extreme pollution

Red

CARE AND MAINTENANCE

Before performing any maintenance work, switch off the air purifier using the on/off button (1).

Use a damp cloth to clean the surface of the product.

Important: Do not use any abrasive materials, as these may damage the surface of the product.

Frequency of cleaning/replacing the filters :

Filter

Clean/replace

Frequency

Filter codes

Pre filter

Clean

Every 2 months

2in1 Active Carbon & filter

Replace

Every 12 months

XD6231

Nan filter 

Replace

Color changing (see 

color chart on filter) 

or every 12 months in 

case of no saturation.

XD6082

These figures are based on tests in which the air purifier is used for 8 hours per day in quiet mode. 

You may need to replace the filters more often depending on the air quality and how often the air purifier 

is used. The filter replacement indicator (7)   will turn on when the filters need to be replaced and you 

will receive a notification on your mobile application. To replace the filters, please refer to the section 

“Disassembling / Reassembling filters”.

Important! When the filter replacement indicator (7)   turns on, please check on the mobile application in 

order to know which filter has to be replaced. If two filters must be changed, please change them one by one. 

Change the second filter only after changing the first one and after resetting the first filter.

•  The pre-filter can be cleaned with a vacuum cleaner or rinsed in water.

Important: Resetting the filter

After replacing the filter, press the mode button (2) 

 for 3 seconds to reset the filter settings. 

Performing a force reset:

If you replace a filter before the end of its lifespan, press the mode button (2) 

 for 3 seconds to reset the 

filter settings. 

Caution :

If the granules become "white opaque", filter needs to be removed from the purifier until the granules 

become transparent again.

If the opaque aspect persists, filter need to be changed.

If the granule become "crumbly", filter need to be changed. 

The appliance efficiency can be reduced if the pre-filter is not cleaned regularly. 

Never use a pre-filter that is still damp. 

The pre-filter is the only filter which can be re-used and washed with water. The 2in1 Active Carbon & filter 

cannot be cleaned and re-used. Never wash with water. The 2in1 Active Carbon & filter must be replaced 

after the end of its lifespan. For optimum performance of the appliance, only use filters provided by Tefal. If the 

Nan filter granules become opaque white or/and crumbly, the filter needs to be changed.

Please note: certain filters may emit a temporary slight odour, due to the transport and storage conditions. 

This odour will vanish and is not dangerous for people.