Compact Shirt & Blouse Ironer
EN
13
NOTICE – Risk of Damage to
Material and Property
■
Steam may rise during operation. For
this reason, do not place the device
under equipment containing electrical
components.
■
Make sure that the connecting cable
is not squashed, bent or laid over
sharp edges and does not come into
contact with hot surfaces.
■
Disconnect the device from the mains
power if a fault occurs or in a thunder-
storm.
■
When you disconnect the device
from the mains power, always pull on
the mains plug and never the mains
cable.
■
Never pull or carry the device by the
connecting cable.
■
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage.
■
Never place heavy objects on the
device or the connecting cable.
■
Use and store the device at room
temperature, do not expose it to
extreme temperatures or temperature
fluctuations.
■
Protect the device from other heat
sources, naked flames, persistent
moisture and impacts.
USE
Please Note!
■
Only connect the device to a plug
socket that is properly installed. The
plug socket must also be readily
accessible after connection so that the
connection to the mains can quickly
be isolated. The mains voltage must
match the rating plate of the device.
■
Do not connect the device along with
other consumers (with a high wattage)
to a multiple socket in order to pre-
vent overloading and a possible short
circuit (fire).
■
Do not use any extension cables more
than 3 m long or cable extension
reels.
■
Always switch off the device first be-
fore the plug is pulled out of the plug
socket. One exception is when the
device has fallen into water or in the
event of a fault.
■
The device is intended primarily for
machine-spun laundry. Do not use the
device to press either dry laundry or
completely sodden laundry. If hand-
washed or non-machine-spun laundry
is to be pressed, thoroughly wring it
out and allow it to dry first.
Set-Up
1. Hang the mounting bracket (
2
) on a
door (up to 4 cm thick, close to a plug
socket) (
Picture C
).
2. Fold down the middle piece of the
mounting bracket as far as it will go
(
Picture D
).
3. Place the main unit (
3
) on the mount-
ing bracket. When you do this, the
contacts (
8
and
6
) of both compo-
nents must engage in one another
(
Picture E
).
4. Fold down the two clips (
9
) of the
main unit (
Picture F
).
04067_Inlay_de-en-nl-fr-es-it_A5_V1.indb 13
04067_Inlay_de-en-nl-fr-es-it_A5_V1.indb 13
09.11.2020 14:44:13
09.11.2020 14:44:13
