Smart active foam generator
i
foam
19-32
operating instructions
The high pressure lance can be used not only for high pressure rinsing, but also for low pressure foaming,
with no need to change the lance or the pistol grip.
Both options are selected on the equipment’s control panel.
Using the high-pressure manual lance:
Once the lance and pistol grip assembly is connected, the
correct nozzle is fitted for the required water dispersal angle.
These nozzles can be found in the upper rear of the equipment.
There are four nozzles for high pressure rinsing and one nozzle
for low pressure foaming.
The connection of the nozzle to the lance is done as shown in
the figure.
5
The lance angle of incidence is set by moving its handle forward and
backwards. The working range is from 20 to 140 degrees.
