IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
RELEASE
9-13-17
REFERENCE
NUMBER
INS-2635-00
Phase 1 - Rough In
Installation of Back box
1. Install Conduit and junction box (By Others) to be
used with this product.
2. Install junction box so that front face
is flush with finished wall or ceiling.
3. Connect box to conduit and pull wires for
connections (See Wiring Diagram).
Additional Info
• Please follow National and Local electrical codes for your area.
• Suitable for through wire.
• Suitable for installation into combustible materials.
• Rated for 90° C.
• Junction box, universal mounting ring screws, box mounting
hardware and gaskets (By Others)
WIRING DIAGRAM
Phase 2 - Finish Installation of Fixture with Power Canopy Ballast.
1. Remove one or two wire entrance knockouts
on wall plate. Pull primary branch circuit wiring
necessary for installation through knockout(s).
Attach wall plate to junction box using
appropriate hardware (By Others). Seal plate as
per NEC.
2. Ground primary branch circuit to wall plate
per NEC. Use waterproof wire connectors
(By Others) to connect transformer
primary leads to branch circuit wires.
See wiring diagram.
PROJECT:
TYPE:
4. Mount canopy to Universal Mounting Ring
with four (4) #8-32 stainless steel screws using
5/64” Allen wrench. Do not over tighten.
3. Connect fixture to transformer secondary side
using provided quick disconnect.
POWER CANOPY™
Low Voltage
Installation Instructions
120V
12V
Fixture
COM
Remote
Transformer
COM
120V
12V
Fixture
COM
GROUND
WIRING DIAGRAM
Transformer
COM
GROUND ON PLATE
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.tekaillumination.com • info@tekaillumination.com
