5. Commissioning
WARNING
Dangers arising from a defective condition of the unit. There is also a risk to the eyes
if there is a direct view of the UV-C lamp.
Make sure that the measures described in this chapter are completed before the
commissioning of the unit. All required connections must be attached before turning the unit
on. Do not operate the unit if any components are defective, missing or damaged. Check the
orderly condition of the unit before switching it on. The unit must not be operated without a
filter element.
NOTICE
Damaged supply lines.
Make sure that the supply lines are protected against damage by forklift trucks and similar
events. Protect all supply lines from heat, moisture, oil and sharp edges.
5.1. Electrical connection
NOTICE
Electric malfunction possible in cause of an incorrect power supply.
Pay attention to the admissible supply voltage. Please observe the specifications on the type
plate.
●
Connect the mains cable (see chapter 2.1) to the power supply.
5.2. Integration in the WLAN and app (“WiFi” version)
This section only applies
●
to the
“WiFi”
device version, not the
“Basic”
version,
●
and if the device version
“WiFi”
can be switched on and off via the app. This then
requires the device to be integrated into the WLAN network and into the app.
Integration in the WLAN is only possible if the network is set to 2.4 GHz. Otherwise the WLAN
must be set to 2.4 GHz, for example in the router settings.
BA_VIROLINE-SMART_200921_EN
7
12.01.2022
