13
EN
Activated charcoal filter
To install the charcoal filter, the motor
anchorage is made to coincide with the
anchor points of the activated charcoal
filter and turn it clockwise.
The carbon filter lasts from three to six
months depending on the particular
conditions of use.
The activated carbon filter can neither be
washed nor regenerated. Once it is
exhausted, it must be changed.
To replace exhausted filters with new ones,
withdraw the old one in the reverse order
to that of installation.
Chang
i
ng Bulbs
Firstly it is important that the mains are
disconnected, and ensure the bulbs that
are to be replaced are not hot.
Remove the light lens to expose the
extractable lamps.
The maximum bulbs power is 20W.
Tecnical Information (Fig. 4)
Dimensions:
Width = 600 mm
Depth = 300 mm
Height = 184 mm
Electrical characteristics:
REFER TO RATING PLATE
Installation
To fix the extractor to the kitchen unit the
pattern on fig. 4 is used.
A:
Outlet for two motors.
B:
Outlet for single motor.
C:
Front of extractor.
The lower part of the extractor must be located
at a minimum height of 60 cm above the hob
for electric cookers and 65 cm for gas cookers.
If the instructions of a gas cooker indicate a
greater distance these must be observed.
To achieve optimum performance the length of
the outlet hose should not exceed 4 meters, or
include more than two 90º angles (elbows).
Although venting to the outside is
recommended, activated carbon filters may be
used, which allow the gas to be returned to the
kitchen through the outlet pipe.
If you wish to exchange the front for one
matching the kitchen units, follow the following
instructions (Fig. 3):
*
Withdraw the movable group.
*
Remove the screws (T) that support
the front.
*
Install the new front fixing it with the
same screws that held the old one.
