Index
Page
Description of the appliance
11
Instructions for use
11
Cleaning and maintenance
12
Problem solving
12
Sizes and specifications
12
Accessories supplied
13
Installation
13
Active charcoal filters
13
A
An electronic programmer device with
TOUCH CONTROL technology to control
speed, light, programming, saturation of the
filters, clock, automatic mode and the
operation display.
B
Metal filters.
C
Lamps - 20 W (G-4).
D, E
Vertically adjustable tubecovers.
Switch on the extractor fan a few minutes before
you start to cook in order to ensure that a steady air
flow has been established before fumes appear.
Allow the extractor fan to run for several minutes
after you have finished cooking (between 3 to 5
minutes) in order to expel all the grease from the
outlet duct. This prevents the return of grease,
smoke and smells.
Activation of the clock:
1) Push the ‘clock’ button.
2) Adjust the flickering hour digits by pressing ‘-‘ or
‘+’.
3) Push the ‘clock’ button.
4) Adjust the flickering minute digits by pressing ‘-‘
or ‘+’.
5) Push the clock button in order to save the
changes.
Light display:
To switch the light display off push the ‘clock’ button
at the moment that the cooker hood is in operation.
When the cooker hood is switched off, the display
will faint away in 40 seconds. To switch the light
display on again, push the ‘clock’ button when the
cooker hood is in operation.
Program the period of aspiration.
1) Switch on the cooker hood and choose the
aspiration speed that you wish.
2) Push the ‘Timer’ button.
3) Select the programming time that you wish by
pressing ‘-‘ or ‘+’. The minimum time is 1 minute, the
maximum time is 99 minutes.
4) After selection of the programming time push the
‘Timer’ button in order to save the changes. The
time and the remaining programming time are
displayed alternatively.
The maximum speed ‘H’ can only be selected
manually and will be changed automatically to the
velocity of level 2 after approximately 10 minutes.
Saturation of the filter:
When the sign ‘Saturation of the filters’ is on, the
filters should be cleaned (turn to page 4: ‘Cleaning
of the filters’). After cleaning the filters push the sign
‘Saturation of the filters’ to switch it off.
Automatic mode:
When the ‘Auto’ button is pushed the humidity
detector will be activated. The sensor will turn red
and the indication ‘auto’ will light up on the right side
of the display.
Depending on the detected level of humidity the
cooker hood will automatically choose one of the
first 3 speeds. A few moments after the
disappearance of the humidity it will automatically
turn off.
If the ‘Auto’ button is pushed while the sensor is red
the humidity detector will be deactivated. The colour
of the sensor will turn white.
Description of the appliance
Instructions for use
You may control the kitchen hood by operating the
controls as shown in the diagram.
EN
G
11
