Teka DX-90 Vr. 03, Instruction Manual

12

ENG 

TEKA INDUSTRIAL S.A. reserves the right to make changes and corrections to its products as
it deems necessary, without altering their basic characteristics.

During cleaning and maintenance work,
make sure the safety instructions set out
on page 10 are complied with. 

• If your kitchen hood is made from stainless

steel, use proprietary cleaners mentioned
in the product instructions.

• Never use metallic scourers, nor abrasive

or corrosive products.

• Dry the kitchen hood using a cloth that

does not produce fibres.

Extract the filters  from their housings using
the handles specially designed for this
purpose.
The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher. In

this case, it is advisable to stack them
vertically to avoid food residues to stick to
them.
Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this
will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit
them onto the kitchen hood.

Fig. 2 (Page 31)
Proceed as follows:
•  Remove the metal filters. Loosen the

screws (without unscrewing them) of the
EASYCLEAN  panels (A), move the panels
aside carefully and take them off.

•  Dismount the supports (C) by loosening

the screws (B).

• Change the broken/burnt out lamp (D).

Maximum lamp power is 20 W (G-4).

•  Mount the supports again (C).
•  Mount the EASYCLEAN panel again (A).

Fit the metal filters.

Cleaning the metal filters

Cleaning the hood body

Cleaning and maintenance

_________________________________________________________

Problem solving

Proceed with the following checks before calling the Technical Service:

Changing light bulbs

Sizes and specifications

See page 30.