Teka GFH-55 User Manual Download

Page: 18 / 104

This fixation  will be  made  from the  inside part of
the  cooker  hood,  after  disassembling  the  filters.
In  order  to  assemble  the  frame  again  once  the
hood  is  installed,  you  will  proceed  in  the  inverse
way.

To the internal laterals of the furniture through

floating holes

denominated “C”, wich exist in each

side of the body hood. This fixation will be made
from the inside part of the cooker hood, after
disassembling the filters.

The lower part of the extractor must be located at
a minimum height of 50 cm above the hob for
electric cookers and 65 cm for gas cookers. If the

instructions of a gas cooker indicate a

greater

distance these must be observed.

To achieve optimum performance the length of
the outlet hose should not exceed 4 meters, or
include more than two 90º angles (elbows).

Although venting to the outside is recommended,
activated carbon filters may be used, which allow
the gas to be returned to the kitchen through the
outlet pipe.

If something does not work

Before seeking technical assistance carry out the
following checks first:

DEFECT

POSSIBLE CAUSE

SOLUTION

The extractor does
not work

The cable is not connected

Connect the mains cable

No current is reaching the
plug

Revise/repair the electricity circuit

The extractor does
not blow enough or
vibrates

Filter saturated with grease

Clean or substitute the filter

Outlet obstructed

Eliminate obstructions

Inadequate air conduit

Contact the installer and follow
instructions of this manual

The lamps do not
light

Lamp broken

Contact the Customer Service
ILCOS D Code: DBR-1,5-H-67

Special U.K. Requirements

Height above gas hob: 75 mm minimum.

NEVER PLACE THE COOKER HOOD OVER AN
EYE-LEVEL GRILL.

This  appliance  must  be  connectec  by  a
competent  person,  using  fixed  wiring  via  a
DOUBLE  POLE  SWITCHED  FUSED  SPUR
OUTLET.

Special Australia Requirements

This appliance is not intended for use by young
children or infirm persons without supervision.

Young children should be supervised to ensure
that they do not play with the appliance.

Electrical connection

We recommend that the appliance is connected
by a qualified electrician, who is a member of the
N.I.C.E.I.C. and who will comply with the I.E.E.
and local regulations.

Should the colour of the wires in the mains lead
for the appliance not correspond with the
coloured markings identifying the terminal in your
spur box proceed as follows:

•

The wire which is coloured blur must be

connected to the marked

(Neutral) or

coloured Black.

•

The wire which is coloured brown must be

connected to the marked

(Live) or

couloured Red

•

Where avialable (see installation), the wire

which is coloured yellow/green must be
connected to the market

⊥

or coloured

Yellow/Green.

If  the  cooker  hood  is  installed  for  use  above  a
gas  appliance  then  the  provision  vor  ventilation
must  be  in  accordance  with  the  Gas  Safety
(Installation  &  Use)  Regulations  1984  and  the
relevant

Building

Regulations.

Detailed

recommendations are contained in the following
British Standard Codes of Practice BS6172,
BS5440 and BS6891 Current Edition.