46
4.
Turn the temperature selector to select
pyrolysis programme P1, P2 or P3, where:
P1: Minimum programme. Duration 1 hour
P2: Standard programme. Duration 1 hour
and 30 minutes
P3: Maximum programme. Duration 2
hours
5.
You will hear 2 consecutive beeps after
several seconds confirming the pyrolysis
programme has been selected. The symbol
will light up on the clock display along
with the time left before the selected
programme comes to an end.
6.
After a few seconds the symbol
will
come on, indicating that the oven door can
no longer be opened since the oven has
star ted to heat up.
IMPORTANT:
At this point, the oven is
programmed and the pyrolytic cleaning cycle
is under way. During the cycle, none of the
timer functions can be selected, except the
child lock. Do not tr y to open the oven door as
it may interrupt the cleaning process.
7.
When the pyrolytic cleaning cycle finishes,
an alarm will sound and the symbol
will star t to flash.
8.
Touch the sensor to turn the alarm off.
9.
The oven’s heating process has finished.
However, the oven is extremely hot and
cannot be used.
IMPORTANT
The cooling process may last up to 2 hours
owing to the high temperatures inside the
oven.
10.
Once the oven has cooled down, the
symbol
will turn off.
11.
Open the oven door and wipe the inside
with a damp cloth, removing the ash
resulting from the cleaning cycle. Areas in
the oven that are difficult to access will
need to be cleaned with a non-metallic
fibre scourer.
12.
Once the oven is clean, do not forget to
replace the suppor ts and accessories.
13.
The oven is now ready to be used again.
IMPORTANT: If any incidents are detected
in the programming and operation of this
function, consult the section “Incidents
while Operating the Pyrolytic Function”.
3172493-000 EPIFA.QXD:- 28/9/11 14:06 Página 46
Summary of Contents for HPL 870
Page 2: ......
