User’s Guide
10
Teka Hydroclean
®
function
This function makes it easy to remove grease
and other food debris that may have stuck to
the sides of the oven.
For easier cleaning, do not allow dirt to accu-
mulate. Clean the oven frequently.
pRoGRaMMING THE TEKa
HYDRoClEaN
PRO
®
FUNCTIoN
WaRNING
Do not pour water into a hot oven as this can
damage the enamel of the oven.
Always run the cycle on a cold oven. The result
could be affected and the varnish damaged if it
is run when the oven is too hot.
First remove the trays and all accessories from
the oven interior, including the tray supports
and telescopic guide rails.
To do this, follow the instructions in the in-
stallation and maintenance guide accom-
panying the oven.
1.
With the oven cold, spread a cloth out on the
bottom of the oven
2.
Gently pour 200 ml of water into the bottom
of the oven cavity.
INFoRMaTIoN
For best results, add a teaspoon of mild
washing up detergent to the glass of water
before pouring onto the cloth.
3.
Turn the control dial to the
position.
4.
You will hear a beep indicating that the Teka
Hydroclean
®
cycle has started. The
sym-
bol will
flash
slowly and the time remaining to
complete the cycle will appear on the display.
IMpoRTaNT
The duration of this cycle cannot be changed.
To stop the cycle before it is
finished,
turn
the control dial to the
position.
5.
When the cycle is
finished,
the oven will turn
itself off, an alarm will sound and the
symbol will flash quickly
.
IMpoRTaNT
Do not open the oven door until the Hydro-
clean
®
function is complete.
The cooling cycle is necessary for the func-
tion to work properly.
6.
Touch any sensor with your
fingertip
to stop
the alarm and turn off the
symbol.
7.
Turn the control dial to the position.
8.
Any traces of dirt and excess water can now
be removed from the oven with the damp
cloth.
The Hydroclean
®
function takes place at a low
temperature. However, cooling times can vary
depending on the room temperature.
If a deeper clean is required after using the Hy-
droclean
®
function, use neutral detergents and
non-abrasive sponges.
WaRNING
Before touching the inside surface of the
oven, make sure that it has cooled properly.
Summary of Contents for HSB 543
