6
Failure to do so can result in death, explosion, fine or burns.
·
To ensure proper ventilation for your refrigerator, allow for 200mm
space on each side between walls, 200mm space between back of
your refrigerator and the wall, and 300mm space between counter
top and the roof or ceiling.
·
If you are installing your refrigerator next to a fixed wall, leave
sufficient space on the hinge side to allow for the door to swing
open.
·
Never install your refrigerator near heat source and direct sun
shins.
ELECTRICAL REQUIREMENT
WARNING:
DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or
electrical shock.
Before you move your
refrigerator
into its final location, it is
important to make sure you have the proper electrical connection.
Recommended Earthing Method
A 220
~
240 Volt /50 Hz AC only 10 ampere fused and properly
earthed electrical supply is required. It is recommended that a
separate circuit serving only this appliance be provided. Use a
receptacle which cannot be turned off with a switch or pull chain. Do
not use an extension cord.
NOTE:
Before performing any type of installation, disconnect the
refrigerator from the electrical source. When you are finished,
Summary of Contents for TS1 130
