105-0717-006 10
Using the Titan III Chuck
Mounting Add-On Jaws
MOUNTING ADD-ON JAWS
Your standard Nova Titan
5in chuck is provided with
PowerGrip add-on jaws.
They need to be located and
screwed on to the jaw slides
of the chuck. The same
procedure outlined below
must be followed for all
accessory jaws as well. IT IS
IMPORTANT TO LOCATE
JAWS PROPERLY IN THE
JAW SLIDES FOR THE
CHUCK TO FUNCTION
ACCURATELY.
Follow the method set out below
1. You will notice that the back of the jaws have a stepped location
ring. This location ring is designed to fit into the grooved section of
the jaw slide for precision location. Ensure that the slide and collet
back are clean and free from any burrs or damage that might affect
location. Place the jaw segment over the hole positions on the jaw.
Press the jaw segment firmly onto the jaw slide. For the first few
times you may need to GENTLY tap the jaws into the locator slot
with a block of wood.
2. The screws can now be screwed in, using the 4mm Allen Key
provided. Lightly grease or oil screws under each head and on the
threads before use to prevent the screws from seizing in the jaw.
Preferably use an anti-seize compound e.g. ROCOL J 166 Anti-
Seize Compound. Do all screws up finger tight and then back them
off one quarter to half a turn.
