å
Carefully stand your unit upright.
å
Fasten the HUTCH UPRIGHTS (C and M) to the TOP (E).
Tighten four TWIST-LOCK® FASTENERS.
å
Fill the holes in the edges of the HUTCH UPRIGHTS (C
and M) 1/4 to 1/2 full with GLUE (54M). Then, insert eight
WOOD DOWELS (15F) into the holes. Wipe away the
excess GLUE.
å
Place drops of GLUE (54M) onto the WOOD
DOWELS (15F) in the HUTCH UPRIGHTS (C and M).
å
Press the HUTCH TOP (F) onto the WOOD DOWELS in
the HUTCH UPRIGHTS. Wipe away the excess GLUE.
Step 9
Page 13
Fill the holes 1/4 to 1/2 full with GLUE.
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely diffi
cult.
Caution
!
54M
15F
M
E
Sur
face without holes
Unfi nished edge
How to use the SAUDER TWIST-LOCK
®
FASTENER
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
Dowel end
M
C
C
(8 used)
F
Surface with
TWIST-LOCK®
FASTENER
Surface without
TWIST-LOCK®
FASTENER
