Step 4
Page 9
å
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into
the PEDESTAL RIGHT END (N) until the shoulders of the
SCREWS rest on the surface of the PEDESTAL RIGHT END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDING (Z) onto the PEDESTAL RIGHT
END (N). Line up the groove in the MOLDING over the
heads of the SCREWS in the PEDESTAL RIGHT END.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
These edges should
be even after the
MOLDING is slid on.
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
32S
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the END.
N
Z
