Step 10
å
Separate the EXTENSION SLIDES (4) from the EXTENSION RAILS (3) as
shown in the enlarged diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (3) to the LARGE EXTENSION BLOCKS (L).
Use four BLACK 1/2" FLAT HEAD SCREWS (19).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the back hole. Then,
slide the inner cartridge of the EXTENSION RAIL in to fi nd the other hole that
lines up with the hole in the LARGE EXTENSION BLOCK. Turn a SCREW into
this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the LARGE DRAWER.
Page 14
Push up on the black lever and pull the SLIDE from the RAIL.
A
C
L
L
4
3
3
3
3
BLACK 1/2" FLAT HEAD SCREW
(4 used in this step)
19
G
Use these holes.
Open end
Open end
Open end
Back hole
Back hole
