Step 12
Page 16
BLACK 9/16" LARGE HEAD SCREW
(6 used for the SUPPORT)
1S
å
Carefully turn your unit over onto its front edges. Unfold
the BACK (F) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (F).
Push on opposite corners of your unit if needed to make
it "square".
å
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
the UPRIGHT (C).
å
Fasten three METAL BRACKETS (4G) to the SUPPORT (P).
Use three BLACK 9/16" LARGE HEAD SCREWS (1S).
å
NOTE: Be sure the edges of the METAL BRACKETS are
even with the edge of the SUPPORT.
å
Fasten the SUPPORT (P) to the BOTTOM (E). Use three
BLACK 9/16" LARGE HEAD SCREWS (1S) through the
METAL BRACKETS and into the BOTTOM.
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
These holes must line up
over the UPRIGHT (C).
NAIL
(48 used for the BACK)
1N
F
P
4G
4G
P
E
Printed
information
must be
facing up
.
