Step
Page 21
Step 16
å
Carefully stand your unit upright.
å
IMPORTANT: You will need someone's help in this step.
å
NOTE: Be careful when lining up the holes in the MECHANISMS with the holes in the ENDS as to not damage any parts.
å
1
st
- Line up the front two holes in each LIFT TABLE MECHANISM (23M) with the holes in the ENDS (A and B) and turn
four BLACK 9/16" LARGE HEAD SCREWS (1S) a few turns into these holes.
å
2
nd
- Line up the bottom hole near the center of each LIFT TABLE MECHANISM (23M).
Completely tighten two BLACK 9/16" LARGE HEAD SCREWS (1S) into these
two holes. Also, completely tighten the fi rst four SCREWS (1S).
å
3
rd
- Finish fastening the LIFT TABLE MECHANISMS (23M)
to the ENDS (A and B). Tighten four BLACK 9/16"
LARGE HEAD SCREWS (1S) into the holes
closest to the rear PANEL (O).
23M
23M
E
A
B
These four holes
must be here.
BLACK 9/16" LARGE HEAD SCREW
(10 used in this step)
1S
O
1
st
2
nd
3
rd
1
st
2
nd
3
rd
1
st
2
nd
3
rd
This hole is used
in the next step.
Do not use.
Do not use.
This hole is used
in the next step.
