Table of Contents
Assembly Tools Required
Part Identifi cation
Hardware Identifi cation
Assembly Steps
Safety
Hammer
Not actual size
3
4
5-28
29
No. 2 Phillips Screwdriver
Tip Shown Actual Size
Skip the power trip.
This time.
Use of a TV that is too heavy or large is hazardous. A TV that is too heavy will create a risk of a tip-over that can cause severe injury or
death. A TV that is too large for the available space might be accidentally pushed or bumped off the furniture, or subject to tip-over.
• Check the size and weight of your TV. Compare it to the diagram below –
before you begin assembly!
• This Sauder unit is designed for use with televisions weighing less than 70 pounds.
Never
use with a TV that weighs more.
• The size of the television, front-to-back and side-to-side, must fi t within the space defi ned in the diagram.
•
Never
place the front edge of the TV past the front edge of the TV support shelf (or stop molding – if equipped)
•
Never
allow the sides of the TV to extend past the side edges of the TV support surface.
• If the TV has a CRT picture tube, the picture tube cone may extend past the rear of the support shelf.
• Be sure to apply the warning label as instructed in the last assembly step. The label provides important safety related information.
WARNING
!
70 lbs.
70 lbs.
16-1/2"
16-1/2"
60"
60"
Page 2