Step 5
å
Separate the EXTENSION SLIDES (2) from the
EXTENSION RAILS (1) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the RIGHT END (A) and
UPRIGHT (E). Use six BLACK 1/2" FLAT HEAD SCREWS (23).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into
the hole shown in the enlarged diagram. Then, slide the
inner cartridge of the EXTENSION RAIL in to fi nd the
other holes that lines up with the holes in the END and
UPRIGHT. Turn a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the
DRAWERS.
Use these holes to fasten the EXTENSION
RAIL to the END and UPRIGHT
Push the black lever down and pull the SLIDE from the RAIL.
1
1
1
2
BLACK 1/2" PAN HEAD SCREW
(6 used in this step)
23
Open end
Open end
A
E
Page 9
Just think. The sooner
you do this, the sooner
you do something else.
