Step 11
å
Turn six ANGLED HEAD CAM SCREWS (3) into the RIGHT END (A).
å
Push two LONG WOOD DOWELS (6) into the short edge of the RIGHT END (A).
å
Fasten two RIGHT CABINET RAILS (II) to the RIGHT END (A). Use six BLACK 1/2" FLAT HEAD SCREWS (18) through the
2nd, 3rd, and 5th holes as shown.
å
Separate a LONG EXTENSION SLIDE (FF) from a LONG EXTENSION RAIL (EE) as shown in the upper diagram. Be
prepared, the parts are greasy.
å
Fasten the LONG EXTENSION RAIL (EE) to the RIGHT END (A). Use three 1/2" PAN HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other two holes that line up with the holes in the RIGHT END. Turn the
SCREWS into those holes.
å
NOTE: The LONG EXTENSION SLIDE will be used later for the DRAWERS.
6
Angled head
Open end
2
2
1
1
3
3
4
4
5
5
1/2" PAN HEAD SCREW
(3 used for the EXTENSION RAIL)
20
Roller end
3
BLACK 1/2" FLAT HEAD SCREW
(6 used for the CABINET RAILS)
18
Push the black lever down and pull the SLIDE from the RAIL.
EE
EE
FF
A
(6 used)
II
II
Page 15
Use this hole.
Use these holes.
