Step 1
å
Assemble your unit on a carpeted fl oor or on the empty carton to avoid scratching your unit or the fl oor.
å
Turn six ANGLED HEAD CAM SCREWS (3) into the LEFT END (B).
å
Push two LONG WOOD DOWELS (6) into the short edge of the LEFT END (B).
å
Fasten two LEFT CABINET RAILS (JJ) to the LEFT END (B). Use six BLACK 1/2" FLAT HEAD SCREWS (18) through the
2nd, 3rd, and 5th holes as shown.
å
Separate a LONG EXTENSION SLIDE (FF) from a LONG EXTENSION RAIL (EE) as shown in the upper diagram. Be
prepared, the parts are greasy.
å
Fasten the LONG EXTENSION RAIL (EE) to the LEFT END (B). Use three 1/2" PAN HEAD SCREWS (20).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the holes shown in the upper diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other two holes that line up with the holes in the LEFT END. Turn the
SCREWS into those holes.
å
NOTE: The LONG EXTENSION SLIDE will be used later for the LARGE DRAWERS.
6
Angled head
Open end
2
2
1
1
3
3
4
4
5
5
1/2" PAN HEAD SCREW
(3 used for the EXTENSION RAIL)
20
Roller end
3
BLACK 1/2" FLAT HEAD SCREW
(6 used for the CABINET RAILS)
18
Push the black lever down and pull the SLIDE from the RAIL.
EE
EE
FF
B
JJ
JJ
(6 used)
Page 5
Use this hole.
Use these holes.
