Step 16
å
Insert the DRAWER SIDES (D550 and D551) at an
angle into the slot at each end of the SMALL
DRAWER FRONT (K).
å
Slide the DRAWER BOTTOM (D985) into the grooves
in the DRAWER SIDES (D550 and D551) and SMALL
DRAWER FRONT (K).
å
Push one HIDDEN CAM (1F) into the DRAWER
BRACE (M67). Then, insert the metal end of a
CAM DOWEL (2F) into the HIDDEN CAM.
å
Fasten the DRAWER BRACE (M67) to the SMALL
DRAWER FRONT (K). Tighten one HIDDEN CAM.
å
Fasten the DRAWER BACK (D552) to the DRAWER
SIDES (D550 and D551) and DRAWER BRACE (M67).
Use five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
Repeat this step for the LARGE DRAWER FRONT (H).
1
2
3
4
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Groove
K
K
K
D985
D552
Unfinished
surface
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
30S
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(10 used in this step)
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
M67
M67
Hidden part using
recycled material.
Color may vary.
Surface with
HIDDEN CAM
Arrow
1F
2F
Metal end
M67
D550
D551
D550
D551
D550
D551
Page 22
