å
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (35MA) to the ENDS (A and B). Use eight GOLD 5/16" FLAT HEAD SCREWS (3S)
through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END. Turn a SCREW into
this hole.
å
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWERS.
Step 2
A
B
Push the black lever in and pull the SLIDE from the RAIL.
35MA
35MC
3
2
1
1
2
3
GOLD 5/16" FLAT HEAD SCREW
(8 used for the RAILS)
3S
Open end
1
2
3
3
2
1
Open end
Page 8
