5/26-34 Dunning Ave, Rosebery NSW 2018 | 1300 313 780 | info@tekniklighting.com.au
www.tekniklighting.com.au
DISCLAIMERS
1.
This product must be installed and used as per these instructions.
2.
This product contains no serviceable parts and no attempt should be made to repair this product. If the
product is faulty it should be discarded.
3.
This product is not suitable for installation in hazardous and/or corrosive areas.
4.
Electrical installations periodically receive transient over voltages. This product has been designed to
minimise the effect of such voltages on connected equipment. It may not give full protection for extreme
over-voltage transients such as those resulting from a close lightning strike.
5.
This product utilises intellectual property in the form of registered designs, trademarks, and/or patents.
Such intellectual property remains the property of Teknik Lighting Solutions Pty Ltd in all cases.
6.
This product has been designed to operate in ambient temperatures -20
o
C to + 40
o
C.
Terminal block is not included. To ensure that the product meets the protection level requirements,
the luminaire must be connected to terminal block with IP66 degree or above.
The terminal block shall be conformed to IEC/EN 60998-2-1 or IEC/EN 60998-2-2 and have the
following specifications:
- Screw terminal block with 3 holes
- Suitable for 1.0-2.5 mm
2
wire
Installation must be performed by a qualified person:
- Brown wire must be connected to L pole
- Blue wire must be connected N pole
- Yellow green wire must be connected earth pole
WIRING DIAGRAM
4
