Step 13
Page 18
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into
the LEFT END (B) until the shoulders of the SCREWS rest
on the surfaces of the END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide two END MOLDINGS (N) onto the LEFT END (B).
Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the END.
å
NOTE: The MOLDINGS should be centered on the END.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
32S
N
B
N
