å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the END (A) until the shoulders of the SCREWS rest on the
surfaces of the END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the MOLDINGS (J and K) onto the END (A). Line up the grooves in the MOLDINGS over the heads of the SCREWS in
the END.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
Repeat this step for the remaining END.
Step 9
A
J
K
BLACK 9/16" FLAT HEAD SCREW
(8 used in this step)
32S
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
These edges
should be even.
Page 15
