Step 1
å
Assemble your unit on a carpeted fl oor or on the empty carton to avoid
scratching your unit or the fl oor.
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the ENDS (A and B). Use six SILVER
3/8" FLAT HEAD SCREWS (11) in the exact holes shown in the upper
diagram below.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL in to fi nd the other holes that line up with the holes in the END.
Turn a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWER.
Page 6
A
B
1
2
Open end
Open end
Push the release lever up or down and pull the SLIDE from the RAIL.
1
1
Edge with
more holes
These holes
must be here.
These holes
must be here.
SILVER 3/8" FLAT HEAD SCREW
(6 used for the RAILS)
11
