Part Identifi cation
Hardware Identifi cation
Assembly Steps
No. 2 Phillips Screwdriver
Tip Shown Actual Size
WARNING
!
Table of Contents
Assembly Tools Required
3
4
5-20
70 lbs
.
70 lbs
.
15-3/4"
15-3/4"
59-7/8"
59-7/8"
Use of a TV that is too heavy or large is hazardous. A TV that is too heavy will create a risk of a tip-over that can cause severe injury or
death. A TV that is too large for the available space might be accidentally pushed or bumped off the furniture, or subject to tip-over.
• Check the size and weight of your TV. Compare it to the diagram below –
before you begin assembly!
• This Sauder unit is designed for use with fl at panel televisions weighing less than 70 pounds.
Never
use with a TV that weighs more.
• The size of the television, front-to-back and side-to-side, must fi t within the space defi ned in the diagram.
•
Never
place the front edge of the TV past the front edge of the TV support shelf (or stop molding – if equipped)
•
Never
allow the sides of the TV to extend past the side edges of the TV support surface.
• Be sure to apply the warning label as instructed later in the assembly. The label provides important safety related information.
Page 2
Electric drill with 5/16" bit
(ONLY in indicated step)
Hammer
Not actual size
