Table of Contents
Assembly Tools Required
Part Identification
Hardware Identification
Hardware Usage Guide
Assembly Steps
Hammer
Not actual size
No. 2 Phillips Screwdriver
Tip Shown Actual Size
2-3
4-5
6
7-46
Page 2
Part Identification
å
While not all parts are labeled, some of the parts will have a label or an inked letter on the edge
to help distinguish similar parts from each other. Use this part identification to help identify similar parts.
A
RIGHT END (1)
B
LEFT END (1)
C
LARGE TOP (1)
D
SMALL TOP (1)
D14 LARGE RIGHT DRAWER SIDE (1)
D15 LARGE LEFT DRAWER SIDE (1)
D20 SMALL RIGHT DRAWER SIDE (1)
D21 SMALL LEFT DRAWER SIDE (1)
D74 SMALL DRAWER BACK (1)
D78 LARGE DRAWER BACK (1)
D716 DRAWER BOTTOM (2)
E
BACK (1)
F
INNER BOTTOM (2)
G
OUTER BOTTOM (2)
H
SHORT TOP MOLDING (1)
J
UPRIGHT (1)
K
LONG TOP MOLDING (2)
L
LEFT FRONT LEG (1)
M
CENTER FRONT LEG (1)
N
CENTER REAR LEG (1)
O
SMALL MODESTY PANEL (1)
P
LEFT REAR LEG (1)
Q
LARGE MODESTY PANEL (1)
R
SKIRT (2)
S
RIGHT END SKIRT (1)
T
SIDE SKIRT (2)
U
END MOLDING (2)
V
LARGE DRAWER FRONT (1)
W
SMALL BRACE (1)
X
LARGE BRACE (1)
Y
RIGHT FRONT LEG (1)
Z
SMALL DRAWER FRONT (1)
AA RIGHT REAR LEG (1)
BB
RIGHT SUPPORT (1)
CC LEFT SUPPORT (1)
