Teknik SMARTBAY One Box, User Manual

Short press “Learn/Erase” button on RC to activate pairing mode, and the 

receiver unit will flash once every second for 3min.

Note: the unit can only pair up to 30 units.    

St

ep

1

The receiver unit (slave unit)

Red LED indicator is on for 3min

Short press “Learn

/Erase” button

St

ep

3

The receiver unit (slave unit)

Red LED indicatoron in on

Erase:

Long press “Learn/Erase” button for 3s to the sensor unit. The 

red LED indicator 

rapidly flash for about 5s. all commands it has received before will be erased.

St

ep

2

The commander unit (master unit)

 The red LED indicator flash one time.

The red LED indicator flash rapidly

when RF signal is received

Short press “Transmit” button on RC, the commander unit (master unit) will 

flash one time to send the transmission signal.  

Upon receiving the transmission signal, the receiver unit (slave unit) will 

rapidly flash 3 times in 1s to indicate the success of pairing. Repeat this step 

to pair more units. One more short press on “Learn/Erase” button to the 

receiver unit to complete the pairing process, the receiver unit will quit the 

pairing mode. 

Note:

Press button RX100%, the light on receiver unit is 100% on upon receiving 

RF on signal; Press “RX STBY%” button, the light(s) goes to preset stand-by 

dimming level directly.`

The receiver unit (slave unit)

Short press “Transmit”

button

Short press “Transmit”

button

RF GROUPING

MALFUNCTION CAUSE REMEDY

CAUSE

REMEDY

The fixture does not light up

The fixture is always on

The fixture is on when it should not

Adjust zone, change installation site

Incorrect daylight threshold setting

Continous movement in the detection zone 

Sudden change in temperature due to weather (wind, 

rain, snow) or air expelled from fans, or open windows

Faulty fixture
No power supply

Adjust daylight threshold setting
Replace fixture
Check power to sensor
Check detection area setting

SECTION 3: TROUBLESHOOTING

1. 

Minimum distance from luminaire to any flammable object is 2m.

2. 

In case of weight discrepancy when replacing old lamps, please ensure that the mounting structure is rated to 

withstand the weight of the new lamp and installation materials. 

3. 

For further information, please contact Teknik (www.tekniklighting.com.au) or your local distributors.

NOTES