å
Separate the WIDE EXTENSION SLIDES (4) from the WIDE EXTENSION RAILS (3) as shown in the
diagram below. Be prepared, the parts are greasy.
å
Separate the NARROW EXTENSION SLIDES (2) from the NARROW EXTENSION RAILS (1) as shown in
the diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1 and 3) to the UPRIGHT (C) and RIGHT END (D). Use twelve 1/2" FLAT
HEAD SCREWS (24).
å
NOTE: For each WIDE EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram.
Then, slide the inner cartridge of the WIDE EXTENSION RAIL in to find the other holes that line up with
the holes in the RIGHT END and UPRIGHT. Turn a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Step 2
Page 8
D
3
4
2
1
1/2" FLAT HEAD SCREW
(12 used in this step)
24
Push the release lever up or down and pull the SLIDE from the RAIL.
Open end
These bumpers
must be here.
1
3
C
This hole
must be here.
Open end
Surface with HIDDEN C
AMS
3
1
