Installation and Connection
1.
1. Pull the detector head from the base part counterclockwise to the short line at the base (1)
and pull it upwards (2).
2.
2. Install the base using the 2 mounting holes shown.
3.
Make the cable connection in accordance with the diagram below. Direction is important in the
connection structure. Connect the (+) feed of the alarm panel to the number 4 and the (-) feed to the
number 1. Connect the zones to number 2 and 3.
4.
Refit the detector head. Make sure the line on the head meets the long line on the base.
5.
Give the detector energy. In the absence of an alarm, the LED on the detector indicates that it is working
by flashing blue every 20 seconds. (the first 15 seconds the detector turns on a blue LED every 5
seconds)
Test
Observable smoke flow should be provided to obtain accurate results.
For smoke testing, allow smoke to enter the smoke detection chamber for at least 1 minute with a flammable
material or test aerosol. When a sufficient amount of smoke enters the chamber, the LED lights up and
notifies the alarm.
1.
When the alarm state is reached, remove the smoke source.
2.
Check that the red LEDs are constantly lit. Reset the detector from the panel.
3.
If the detector does not alarm within 1 minute, contact with your authorised dealer.
4.
The system can be activated after the test is performed.
Manufacturer
*Complies with WEEE regulation. This product is made from recyclable and reusable high quality parts and
materials. Therefore, do not dispose of the product with domestic or other waste at the end of its service life.
Take it to a collection point for the recycling of electrical and electronic equipment.
Bilgi Elektronik San. ve Tic. A.Ş.
Dudullu Organize Sanayi Bölgesi 1. Cadde İsmet Tarman İş Merkezi
No:1 Kat:2 No:32 Ümraniye / İstanbul
/ Türkiye
Telefon:
+90 216 455 88 46
Faks:
+90 216 455 99 06
www.teknim.com
A: Head
B: LEDs
C: Base
ALARM PANEL
