Teknion PLTDS, Manual

10.2022  DIGITAL LOCKS & KEYS

9

in assigned functionality

6

094361

28643

139567

811254

5379

6924

1

2a

2b

094361

28643

139567

811254

5379

6924

1

3

2a

4

2b

. 

3

2

1

Collect all remaining and replacement user credentials (User Codes and User Keys).

Insert the Manager Key again. Three sets of two-tone beeps will be heard, and the 

LED will turn off. All previously assigned user credentials will be removed. 

Follow 

Assign User Credentials

 instructions to assign the remaining and 

replacement user credentials to the locks.

remove user credentials

Make sure the lock is in assigned use functionality (a green LED will flash when     is pressed). The locks must be 

reprogrammed to remove user credentials from operating a lock. 

Press                            . The LED will flash. While the LED is flashing, insert a 

valid Manager Key. A two-tone beep will be heard.

03.2022  DIGITAL LOCKS & KEYS

8

in assigned functionality

4a

4b

3

1a

1a

2a

2

2b

1b

1b

1

2

4a

4b

3

1a

1a

2a

2

2b

1b

1b

1

2

4a

4b

3

1a

1a

2a

2

2b

1b

1b

1

2

Assign User Codes:

Assign User Keys:

Press                           . The LED will flash.

While the LED is flashing, insert a valid Manager Key.

A two-tone beep will be heard, and the LED will turn on.

Go to a lock already programmed  to 

operate with the user credentials  and 

Manager Keys.  Press                           . 

The LED will flash.

*The Programming Key will continue to function in Express Registration mode until it is used to operate a lock.

Insert the Programming Key to  

program each lock to operate  with the 

same user credentials and  Manager 

Keys. Two sets of two-tone beeps will be 

heard, and the LED will flash twice to 

indicate successful programming.

While the LED is flashing, insert the 

Programming Key. A two-tone beep 

will be heard, and the LED will turn 

off. 

End Express Registration mode:* 

Go to any programmed lock. 

Press             then insert the  

Programming Key.

Press                           . The LED will flash.

While the LED is flashing, insert a valid Manager Key.

A two-tone beep will be heard, and the LED will turn on.

While the LED is on, press       [new 4-7 digit code]      . A two-tone beep will be 

heard. Press        [the same 4-7 digit code]      . Two sets of two-tone beeps will be 

heard, and the LED will turn off. 

While the LED is on, insert a User Key. Two sets of two-tone beeps will be heard, 

and the LED will turn off.

assign user credentials

express register user credentials and manager keys

Make sure that the lock is set for assigned use functionality (a green LED will flash when       is pressed). Up to 20 user 

credentials (User Codes and/or User Keys) may be assigned to each lock. 

Make sure the lock is set for assigned use functionality (a green LED will flash when       is pressed). The Programming Key 

can quickly program multiple locks to operate with the same user credentials and Manager Keys.