TKR1222
TKR1222
TKR1525
M3x14mm Cap Head Screw
x4
TKRBB05134
Ball Bearing (5x13x4)
x2
TKR1222
13x16x0.1mm Diff Shim
x2
TKRBB05134
TKRBB05134
TKR8152
TKR1603
TKR1525
TKR1525
Front
Note: flat spot
Rear
Note: flat spot
TKR1603
M5x4mm Set Screw
x1
TKR1226
5x7x0.2mm shim
x1
Grease
Inner Bulkheads
TKR5075
TKR5016B
TKR8152
TKR5016B
TKR5269
TKR1222
TKR1529
TKR5181
TKR1525
TKR1222
TKR1525
TKR1226
TKRBB05134
TKRBB05134
TKR1603
TKR1525
TKR1529
TKR1529
M3x20mm Cap Head Screw
x1
Bag D
Rear Gearbox
(overview)
6
Step
D-1
Step
D-2
Step
D-3
Thread
Lock
Note: The front and rear of
the car use different inner
bulkheads. The front is angled
whereas the rear is
only slightly angled.
*These may not be needed
*These may not be needed
*These may not be needed
*These may not be needed
TKR1226
Note Step D-2: To properly shim the diff, start by test fitting the diff with no shims and check for
side to side play. If no (or very little) play is present, then continue on to the next step. If you feel
excessive side to side play, then start by adding one shim on the gear side of the diff assembly. This
will move the mesh tighter and remove any play. If the mesh is too tight at this point, move the shim
to the other side. In some rare cases, two shims may be necessary.
Summary of Contents for EB48.4
Page 1: ......
Page 26: ......
Page 27: ......
Page 28: ...Tekno RC 10755 Scripps Poway Pkwy 598 San Diego CA 92131 USA ...