Stock Position
(”D” Block)
Stock Position
(”C” Block)
30.2
TKR1601
TKR1601
TKR1601
TKR5086
TKR5493 - 2.6mm
TKR5086
Install the sway bar ball onto the
sway bar wire until the end of
the wire is flush with the ball as
picture above.
Note: Loosen the M3x4 set screw (TKR1601)
if the anti-roll bar does not turn freely.
Note: Do not over-tighten
TKR5049A
TKR5163
TKR5164
TKR5165
TKR5430
TKR1601
TKR5079A
TKR1522
TKR1522
M3x8mm Cap Head Screw
x2
Bag F
Rear End
*TKR5490 - 2.3mm
*TKR5491 - 2.4mm
*TKR5492 - 2.5mm
*TKR5494 - 2.8mm
*TKR5495 - 3.0mm
(Option)
Thread
Lock
Thread
Lock
8
TKR1327
TKR1333
M3x40mm Flat Head Screw
x2
TKR1238
M4x10mm Droop Screw
x2
TKR5049A
Pivot Ball Sway Bar
x2
TKR5079A
Stabilizer Ball
x2
TKR1529
M3x20mm Cap Head Screw
x2
TKR1327
M3x16mm Flat Head Screw
x2
TKR1333
TKR1333
TKR1238
TKR1529
TKR1601
M3x4mm Set Screw
x6
Step
F-1
Step
F-2
Step
F-3
TKR5020
TKR5165
TKR5065
Note: With these stock
center dot settings,
Anti-Squat = 2° / Rear Toe = 3°
Use a #19 drill bit or
4mm reamer to ream
arms until hinge pin
falls through freely.
Summary of Contents for ET48.3
Page 1: ......
Page 26: ......
Page 27: ......
Page 28: ...Tekno RC 10755 Scripps Poway Pkwy 598 San Diego CA 92131 USA...
