8-1
8. CUSTOMIZING THE BOARD
8.1 PROCESSOR AND FAN
Your board will be installed with one of the available Mobile Pentium II processor: 233MHz,
266MHz or 300MHz, and its adequate cooling system.
8.1.1 Installing Microprocessor
Since CPUs are very sensitive components, particular attention should be given while
installing a processor on the board. The CPU core voltage must be set at the adequate value
using the W1 jumper and according to the following table:
W1 Jumper Setting
Processor
Core Voltage
1-2
1-2
3-4
5-6
7-8
Vcore
MP II 233MHz
1.7V
on
on
on
off
on
1.69V
MP II 266MHz
1.7V
on
on
on
off
on
1.69V
MP II 300MHz
1.6V
on
off
on
off
on
1.59V
WARNING
Careful attention should be taken when installing a processor: Faulty
jumper settings can damage both the board and the processor.
Please refer to Section 9 –
Setting Jumpers
for a complete information on the available core
voltage values and associated jumper settings.
Summary of Contents for TEK-CPCI 1003
