Customizing the Board
8-3
8.3 INSTALLING MEMORY
8.3.1 SDRAM System Memory
The TEK-CPCI-1003 supports three 168-pin DIMM (Dual In-Line Memory Module)
sockets for memory configuration from 8MB to 384MB of Synchronous DRAM (SDRAM)
or 768MB using RSDRAM (Registered SDRAM).
The memory characteristics must conform to the following:
§
1.15 inch height,
§
Standard 3.3V only,
§
64-bit and 72-bit modules, single-sided or double-sided,
§
Unbuffered 66MHz (SDRAM),
§
Serial Presence Detect (SPD) EEPROM,
§
Errors Checking and Correction (ECC) capabilities or parity bit with 72-bit
modules,
§
Compliant with Intel’s PC SDRAM Unbuffered DIMM Specification
(66MHz) Rev. 1.0.
At least 8MB of memory must be installed on the board for proper operation. Modules can
be installed in any socket and order. The total system memory is equal to the sum of the
memory module size installed in the three DIMM sockets.
NOTE
When populating with more than one memory module, each socket
must be installed with the same memory type (64/72-bit), however the
capacity of each module may be different from the other.
Summary of Contents for TEK-CPCI 1003
