VIPer Software Setup 9-7
STANDARD SETUP
This part of the setup allows you to set the time, date, hard disk type, types of floppy
drives, monitor type, and whether the keyboard is installed.
The Standard Setup screen displays seven icons as follows:
Pri Master
Sec Master
Pri Slave
Sec Slave
These four hard disk drive icons are for configuring hard disks connected to the VIPer808
or to a peripheral board. Select the appropriate hard disk drive icon (Pri Master = C:
drive).
For each hard disk, these options can be defined: TYPE, LBA/LARGE MODE, BLOCK
MODE, 32BIT MODE and PIO MODE. TYPE and PIO MODE can be Auto detected if
the hard disk drive is an IDE drive: the Auto option automatically finds all of the IDE
drive parameters for that hard disk. You should check your hard disk data sheets to know
if any of the other options - LBA/LARGE MODE, BLOCK MODE and 32BIT MODE -
should be set to ON; if your hard disk supports these modes, enabling them will optimize
your system.
F
It is possible that the parameters provided by Auto detection do not match the
ones found in your drive's literature. This should not be considered an error. As
a matter of fact, different combinations of heads, cylinders and sectors that
match the disk's size will work when formatting an IDE hard drive. But if the
disk is already formatted, it is not possible to use different parameters than the
ones that were used when the drive was originally formatted.
Date/Time
The current values for each category are displayed. To change the date or time, highlight
the values you want to change, and press the + or - key or click the + or - box, until the
desired value is displayed.
Floppy A
Floppy B
The settings are: 360KB 5¼ inch, 1.2MB 5¼ inch, 720KB 3½ inch, 1.44MB 3½ inch,
2.88MB 3½ inch, or not installed.
Summary of Contents for VIPer808
