Kona Macro User Guide
T0004279_UG
Version 1.1
TEKTELIC Communications Inc.
Confidential
Page 17 of 34
3
Commissioning and Monitoring
3.1
Required Equipment
The following equipment is required for commissioning and monitoring the Kona Macro
Gateway.
1.
A laptop running Windows XP/Vista/7.
2.
A Cat5 or better Ethernet cable.
3.2
Procedure
Once the DC power and GPS and LoRa RF antenna connections are in place the Kona Macro
Gateway may be commissioned.
1.
Connect an Ethernet cable between the Host PC and the bulkhead copper Ethernet
connector (RJ45). For a PoE powered installation, a PoE power injector may be required.
2.
Apply DC power to the Kona Macro Gateway. The initial current draw is expected to be
greater than 0.1A. If there is no current, the polarity of the DC power cable connection
may be reversed or the power source may not be configured properly.
3.
The Kona Macro Gateway supports DHCP; from the Gateway MAC ID label on the
enclosure, determine the IP address using your local DHCP tools.
4.
Install the Tektelic Kona Factory Test Tool on a PC and follow the operating instructions
as detailed in the reference document T0004142_GUI_Instructions.
