. Take one of the provided cab lift bol
ts, a ½” x 4
½
”
hex bolt, and bolt to the tab in the top
upper corner of the door opening; weld nut is located behind the tab. Repeat for the other
side.
. Use a lift strap or chain, and connect the lift bolts together. Attach to an over-head hoist or
fork lift and prepare to lift the cab off shipping pallet. Remove the bolts attaching cab to
shipping bracket and then lift cab up.
. Position the cab straight above the tractor and slowly lower down onto the tractor until the
isolators are contacting the steel mounting plates.
REAR MOUNTS MUST BE INSTALLED FIRST,
do not get front mounts started until after the rears are in!!!!
Use the provided 5/8” x 3” hex
bolts, heavy flat washer and flange nuts, and start all four mounting bolts. The heavy flat
washer needs to be located properly to ensure proper fastening. It is located between nut and
the isolator from underneath. If front mounts go in first, it will be VERY difficult to get rears
started.
June 2021© Massey GC1725M ROPS Cab Installation Manual
