IL573 Tek-ENTRY
®
Telephone Entry System Phone-Line Version Manual • 9
Copyright © TekTone Sound & Signal Mfg., Inc. All Rights Reserved.
System Installation and Programming
5. If the indicator is on steadily, the sensitivity is set too high and the door circuit may false
trigger. Turn the shaft of the potentiometer counter-clockwise to decrease the sensitiv-
ity. The sensitivity may also require reduction if the phone line is particularly loud or
noisy. NOTE: Sensitivity adjustments are not required when using DTMF (touchtone)
suite telephones.
Notice to U.S. Installers and Users
Incidence of Harm
Should terminal equipment or protective circuitry cause harm to the telephone network,
the telephone company shall, where practical, notify the customer that temporary
discontinuance of service may be required; however, where prior notices are not practical,
the telephone company may temporarily discontinue service if such action is deemed
reasonable in the circumstances. In the case of such temporary discontinuance, the
telephone company shall promptly notify the customer, who will be given the right to
bring a complaint to the FCC if he feels the disconnection is not warranted.
Changes in the Telephone Company Equipment or Facilities
The telephone company may make changes in its communications facilities, equipment,
operations or procedures, where such action is reasonably required and proper in its
business. Should any such changes render the customer’s terminal equipment incompatible
with the telephone company facilities, the customer shall be given adequate notice to
make modifications to maintain uninterrupted service.
General
The FCC prohibits customer-provided terminal equipment to be connected to party lines
or to be used in conjunction with coin telephone service. The Tek-ENTRY
®
Telephone
Entry System is equipped with a USOC RJ11C standard miniature modular jack that is
designed to plug directly into a modular jack.
Notification to the Telephone Company
Notification to the telephone company is no longer required prior to connecting the
registered equipment; but upon request from the telephone company, the user shall tell
the telephone company which line the equipment is connected to, as well as the registration
number and ringer equivalence of the registered protective circuitry. In most, but not all
areas, the sum of all REN’s should be 5.0 or less.
Malfunction of the Equipment
In the event that the Tek-ENTRY
®
Telephone Entry System should fail to operate properly,
the customer shall disconnect the equipment from the telephone line to determine if it is
the customer’s equipment that is not working properly. If the problem is with the system
equipment, the user shall discontinue use until it is repaired. In the event service is needed,
the user should contact the local TekTone
®
representative.
Telephone Connections Requirement
Except for telephone company provided ringers, all connections to the telephone network
shall be made through standard plugs and standard telephone company provided jacks,
or equivalent, in such manner as to allow for easy and immediate disconnection of the
terminal equipment. Standard jacks shall be arranged so that if the plug connected thereto
is withdrawn, no interference to the operation of the equipment at the customer’s
premises—which remains connected to the telephone network—shall occur by reason of
such removal.
FCC Notice
This equipment generates and uses radio frequency energy and if not installed and used
in strict accordance with the instructions listed in this
Operation, Installation and Service
Manual,
interference to radio and television reception may occur.
