Analyzing waveforms
4.
To take measurements between two
waveforms, select
Waveform
, and then
select the waveform source for each
cursor.
5.
Select
Cursors > Cursor Position...
,
and then use the multipurpose knobs to
adjust the cursor position.
6.
Read cursor measurement results in the
display.
Quick tips
Use the Cursor Track Mode to set the cursors to move in tandem. Use the Cursor Independent mode to move the
cursors separately.
If you use the zoom graticule, you can place a cursor directly on a speci
fi
c waveform point to take precision
measurements.
You can also move cursors by clicking and dragging them to a new position.
You can also move cursors to the center of the display by pressing
Move Cursors to Center
.
You can select solid or dashed cursors.
Vertical cursors measure the time from the trigger point to the vertical cursor.
126
MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series User Manual
