Application examples
Triggering on buses
You can use your instrument to trigger on I
2
C, SPI, RS-232/422/485/UART, MIPI DSI-1, MIPI CSI-2, 8B/10B, USB, CAN, and
parallel buses. The instrument can display both physical layer (as analog waveforms) and protocol level information (as
digital and symbolic waveforms).
NOTE.
Some trigger types are not available on some instruments.
For detailed bus triggering procedures, use the following procedures: (See page 80, Triggering on a parallel bus.) and (See
page 83, Triggering on a serial bus.)
To set up the bus trigger:
1.
Select
Vertical > Bus Setup
.
2.
Select a bus type.
3.
If you selected the
Serial
Bus Type,
select the type of serial bus.
4.
Specify the components.
5.
Select Trig > Bus Setup.
MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series User Manual
173
