Model 4299-2 Dual-Unit Rack-Mount Kit Installation Instructions
PA-909 Rev. J April 2021
3
Prepare the instrument
To remove the handle, mounting ears, and rear feet:
1. Gently pull the handle (1) away from the sides of the instrument case and swing it up or down until the
orientation arrows on the handles line up with the orientation arrows on the mounting ears, as shown in the
following figure.
Figure 1: Rack-mount kit handle removal
2. After you align the arrows (2), pull the ends of the handle (1) away from the case.
3. Remove the screw that secures each mounting ear (3).
4. Pull down and out to remove each ear.
Figure 2: Mounting ear removal
5. From the bottom of the instrument, pull out the rubber feet and remove the screws (4), see the following
figure.
Figure 3: Instrument rubber feet removal
6. Store the handle, rubber feet, and hardware for future use.
